Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am attempting to introduce a new UTM appliance within our network and I want to cutover subnets one at a time for testing purposes starting with us in IT.Currently all user traffic not destined for our network follows a default route of 0.0.0.0 0.0...
Next week our company will be turning up a full rate DS3 and I am trying to figure out what is the best method to manage (limit) how much bandwidth a protocol can potentially use. Right out of the gate I want to only allow 15Mbps (in and out) of the...
I am currently running Call Manager 3.1(2c) and need to upgrade a users phone to support more than 6 line appearances. I have checked to ensure that 7970G's are supported on my current level of CM. I don't have a 7970 template on my CM. Can anyone pl...
I have a 5509 that is showing a peak load on switching bus C of 49%. Is there a recommended maximum threshold to be watched for? sho sys displays a peak of 32%.
This past Saturday I reconfigured one of our remote sites networks to add VLAN?s. The site has a 3620, 4 - 3524 powered switches (users) and one 2970G-24TS (servers and power users). Once the configuration had been completed, I tested the new VLAN?s ...
Giuseppe, Our 5509 does not have a RSM or an RSFC on the supervisor, all of our inter-VLAN routing is being handled on our core router. The router and 5509 have an ISL trunk that ties them together.I have actually wondered about if the next-hop avai...
Hey Giuseppe, Below are the results of the sh mls command. I also ran a sh mls entry and this came back with no active mls rp. When you asked about an RP earlier, I was thinking of something else completely. I'm not sure where else to look unless y...
Giuseppe, Our core router isn't acting as a RP. its there for the NFFC on our SUP3 in our 5509 core switch. All inter-VLAN routing is being done on the core router. Is this what is most likely causing my problem? Any way to work around it? I have ...
I have exactly the same scenario, here is the access list and the interface that I have the list applied to. I am only allowing this subnet access to obtain a DHCP address, DNS resolution and web access. I am also performing rate limiting so that use...
