Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi every bodyI have been struggling to understand the link selection process in ether channel.I find conflicting material about it.For example, in ccnp bcmsn guide by david hucaby , i find the following:For a two-link etherchannel, a 1-bit XOR is per...
hi every bodyi have few questions about trunking between two switches. Should the ports being used on both switches be in same vlan for trunking for example: sw1 has follings configf0/1-f0-0/5 in vlan1f0/6- f0/10 in vlan2sw2 has following config:f0/1...
hi every bodyi want to know following:what is the purpose of bvi?An access point needs only one ip address for management then why do we need bvi?thanks
hi every bodyi have question. i can explain better with the help of scenario.An access point is connected to wired network via fast ethernet (ip address 192.192.192.192). can we configure different ip address for example 194.194.194.194 on bvi in...
Thanks Andrew. I had already read this link before. I am looking for detailed working of lwapp,with packet header field etc.I really appreciate your reply thanks again.
