Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3750 (WS-3750G-24TS) that I am trying to upgrade with no success thus far. I ftp the image to the flash, verify the image successfully, and then reboot. On boot the image loads for a while then I get the "Error loading image:..." then it lo...
Is it possible to load the startup-config from disk0? My 6500 configs are considered classified and I need to be able to pull the configs easily for storage. Also, storing the classified configs on the nvram has implications if the system needs to ...
I am evaluating CSM as a replacement for VMS, but I can't seem to add my IDSM2 and FWSM modules.I tried adding the modules directly, but then I read something that said I needed to add them through my SUP. Is this correct?When I try to add the IDSM2...
Is it possible to run LMS 2.5.1 with a LMS 2.6 license? I deliver LMS 2.5.1 as part of a system and our software baseline is 2.5.1 Since 2.5.1 went EOL I can only purchase 2.6 licenses but my new customers still need to use 2.5.1. Is this at all po...
Thanks, but I have already verified the boot path, and the image actually starts to decompress. ( Loading...@@@@@@@@) I get about 6 lines of "@" and then I get the error.
From what I can gather, you may need to upgrade to 12.2SX for this module to work. According to this page, is says this module is compatible with IOS and CatOS:http://www.cisco.com/en/US/products/hw/switches/ps708/products_data_sheet0900aecd8017376e...
