Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hai everybdy,I have my set up this way between two diffrent areas/subnet.IP routing is enabled between 3750(1st).what will b the default gateway for pc's in 2960?3750(2nd) has 2 interfece with ip routing enabled(as it has diff subnet)can somebdy expl...
Hello,i got sudden quest about SFP port,Does it need to be given IP address?Suppose two 3750 switches which are 10 KM apart, are connected thru Single mode fiber.Does it need totally two IP addresses at the ends?Do we need to provide IP address fo rt...
I have 2950-24 non-LRE switch.I have isolated the switch and powerd on.This is wat i found... All LEDs were Green for a minute...Then Stat LED was Alternate Green /Amber for 2 sec(where all other LED was Amber)Then all LED went Amber except UTIL,whic...
Hai everybdy,We have two 2950 switches.20 PC's are connected to each 2950.They were working fine till now.....suddenly ,the primary one started blinking orange...wat wud be the reason?i have tried resatrd it.....its is highly important as it is in re...
Hai all there,Iam lookin for software upgrade fo r4500 series to 12.4(11)T.where can i download it frm cisco site?can anybdy give me the link?thank u in advance...
Hi aijaz,Here i hav attached the text file....i came to know it is crashed but...wats the reason? an dwat sud i do to fix it?waiting fo rur reply....thank u in advance
Thank u aijaz,But the switch reboot every 3 min....How to capture the boot sequence if this is the case?I can use console and Hyper terminal to enter switch configurations...later how to capture the boot sequence ?lookin forward to c ur reply,
Hai Mark,Thank you for the response...Well the website gave me enough information....But need ur help again....I have 2950-24 non-LRE switch.I have isolated the switch and powerd on.This is wat i found...All LEDs were Green for a minute...Then Stat L...
hai narayan,i have two layer 2 switches(2960),two layer 3 switches(3750) and 2960 switches to either of 3750 switches.i have enabled "ip routing" in 3750 and i want to configure HSRP peer group in Layer 3 switches(3750).do i have to connect 3750 swit...
