Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
To KISS it I have a 6509 connected to 2 7206's..One MPLS and one is AVPN. Far end is 2 2811's and a 3560 layer 3 switch.We are running a mGRE tunnel across the AVPN so the 6500 to each remote router shows a equal EIGRP path. And both links are carr...
We have a winx server running 2.6..It started crashing every week over the last few weeks. What I am finding is the logs for this saturday are empty before the reboot ( 6am ) but the nioght before looks like it stopped the service.-----------------...
I have been trying to upgrade a secure ACS appliance to 4.1 and having issues. If I use the recovery CD TAC had me build it boots and lets me select " re-image hard drive" etc but I loose console access. If I watch the monitor the upgrade (ghost) s...
Thanks, I can't open the bug but can you tell if this is a bug that is going to cause a switch failure or just a pain in the rear log? Reason I am asking is rebooting this switch will require a outage on some key server but if the switch is failing ...
Somu, it is running 12.2 (46) I did run the command but not sure what this output means?It just started and the switch seems to be running normal other then this alert every few seconds.Thanks in advanceMark ayashOSH-AS121-ST01#show platform port-a...
I can't find a lot about it..Just that one thread you listed..Strange part is it staretd today when I enabled a 2nd uplink to the core. We had to replace a blade in the 6509 so early in the week I had shut one port down and brought it back up after ...
Yeah it's a remote site across the WAN and seems to favor one side. Today I am summarizing the class C vlans into a class B..Might remove the statement off eigrp, what I read about CEF if it like different ip's..Today it see's a 10.177.0.0 as the rem...
