Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys I have an SCE 2000 which failed after installation. the problem is i cant get access through the console, it does not respond. when i get access through the AUX port, the first prompt is [VxWorks Boot] if i try to reboot it gives the error ca...
Hi i have a direct connection btn two switches but when i ping one of them from the other it only does atmost 60% passthrough. that means connection to core servers also suffers. any ideas?
Hi, I have been working with WLAN controller 4402 for a while now however some strange thing happened this morning. all registered LWAP APs disappeared. upon rebooting, all of the APs came back (registered) but started disapperaring one by one after ...
Hi,am running CCM 5.1 and using MEIPS 3.x for billing. however am not able to generate reports based on forced authorization codes. some one mentioned that this is possible if the CCM sends the FAC's together with CDRs. this i suppose is not happenin...
Hi while installing ACS 4.1 for windows, there was no option for setting admin username and password. how can i login into it? in the installation guide there is no default username and password. help
hi Giuseppe,this how the setup is sw1 is a vtp server with all the vlans that propagete to sw2 whose users entirelly belong to vlan6. i have an int vlan 6 svi on sw1 with ip add .1 while the svi at sw2 has ip add .9 sw2 can only ping 20% or 0% to .1 ...
Thanks so much guys for your insight but it is also interesting to know that an IP conflict caused all those symptoms. the AP Manager interface IP address was allocated to another device in the network.
Hi, I checked the time on the controller and adjusted it accordingly but the same thing keeps happening. the debugs show the controller receiving LWAPP Discovery Requests and responding succefully yet nothing else happens.below is some logsP Disassoc...
HiAfter setting all the required fields in the MEIPS -> PBX1 -> Configuration, please start the MEIPS SFTP Server (you can find it in the MEIPS installation directory: SFTPServer.exe) go to CCM admin site and select Cisco Unified Service then from th...
