Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an issue with ASA 5510 Firewall.I have three interfaces X,Y and Z, where X has a security level of 0, Y=0 and Z=10.I need to access hosts on Y from Z.As of now it works fine with NAT.All i want is to access hosts with no NATing.I have applied ...
Working on setting up VPN backup on ADSL over ISDN HWIC card HWIC-1ADSLI in 2801 router with IOS ADVIPSERVICES 124-9.T5 in slot 1. The HWIC does not get past "initializing". Have tried various configurations and rebooted router twice.Any help would ...
HiI'm using CME 3.3 on 2800 router. Also using 7912 and 7940 and 7960 phones.The issue is like this.When the People in our plant are in a call and they try to adjust the reciever volume because they are in a loud environment,Then the external speaker...
I'm facing a issue with OSPF. The neighbor relationships shows that its still in the init state.We have a tunnel interface and the source is the dialer interface through which the updates are passing.The tunnel mode used is ipsec ipv4.I want to know ...
Hi AllThe Cisco 1200 WAP, when logged shows me the fowarding state as Blocking.When the carrier test is run, it shows me as busy. Can any one tell me shat can be the cause.I suspect the STP should be the issue here.Regards,Vijay
Thanks for the information.Do we have any document for this? I have searched in Cisco, but was not succesfull in getting it. So i would request,if you have any document for this to forward to me.
