Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
i am currently struggling with the migration of a ACS/TACACS based ISDN dial in solution to ISE 2.3.
My problem is finding the missing bits under ISE. And if it's generally supported or works at all.
I have configured a couple of Cisco AV-pairs e...
Hi everbody,i'm trying to run the little script bellow via cut&paste....However, the next command "tclquit" after calling the proc isn't running! Nor any other command...Is there a trick to terminate such cut&paste proc's?( in my case i need to work ...
Hi,I'm looking for a way to automate vlan and vlan name configuration with tcl!e.g.vlan x name xxxvlan y name yyyUnfortunately the tcl command "ios_config" let me configure vlans but vlan sub-commands, like "name xxx", are not possible!ios_config d...
Hi,we are planning to use 7600-SIP-400 with SPA-2X1GE-V2. Can anybody assure that the two rj45 ports at the SPA-2X1GE-V2 supporting 10 or 100baseT connections? (speed 100) Thanks Christian
We are planning to use 7600-SIP-400 with SPA-2X1GE-V2.Can you assure that the two rj45 ports at the SPA-2X1GE-V2 supporting 10 or 100baseT connections? (speed 100) ThanksChristian
uups, ok...with the "end" parameter ios_config command works fine for vlan/name configuration!Within interface configuration i never used the "end" before.I didn't understand the exactly reason behind the difference, but it works and i'm fine!Vlan co...
