obaroikoh
Level 1
Level 1
Member since ‎07-08-2015
‎08-18-2017

User Statistics

  • 21 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies

User Activity

Hello House, I have a couple of devices I want to monitor remotely using Solarwinds or PRTG. I need to configure SNMP to get it to work but don't know How. I tried the following commings but it didn't work access-list 100 permit udp any eq snmp des...
I have a cisco 881 router. I want to to have two network addresses on it. I have create SVI i.e int vlan 2 and int vlan 3 but host connected to these vlans can't communicate with themselves. How do i go about this. Thanks for your assistance
I have three routers connected via point to multi point (R1 to R2 and R3). I want to split the bandwith i'm getting from my ISP between R2 and R3. R1 is connected to my ISP. what do i do? Thanks Heres's a use case. I'm getting 2Mbps from my ISP comin...
I have 3 routers, R1 and R2 are connected directly via primary and secondary IP address. R3 is connected to R2 with a primary address. i configured static routing on R3 so it could connect with R1 using its secondary address. when i checked to see if...
Community Statistics
Member Since ‎07-08-2015 01:23 AM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 21