Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have setup a PIX 515 running v803 for remote access from a VPN client. I cyrrently have site-to-site VPN's which have been setup and work fine. Currently, when i connect using the VPN client (v5), although Phase 1 completes Phase 2 does not, I j...
Hi, I am running v8 of the PIX software with the following config: inside interface - sec level 100outside1 interface sec level 0outside2 interface sec level 2My question is this, if I have a single nat exemption statement i.e. 'nat (inside) 0' and 2...
Hi there, I have a question regarding Trunking and Etherchannel. Let's say I have 2 2950's with 2 trunk links between them. Both trunk links are in a Channel group (either with or without negotiation).No let's say I put a hub in between each of the t...
Hi, what is the lowest IOS version anyone has had etherchannel working on? I am trying to setup etherchannel between a 2950 and a 3500. The 3500 has the ios c3500xl-c3h2s-mz-120-5.3.wc.1.bin. However, i don't have the channel-group interface command ...
Hi,I have several 2960's and a 3750. Currently I have created several VLAN's, and the 3750 is configured for intervlan routing. I would like to use the 3750 for DHCP. How can I create multiple pools and ensure ip addresses are allocated to the right ...
I noticed the following on Cisco's site. The two main things from this seem to be:- I won't be able to manage any of the 4 access points over IP? (Although, if I'm using 802.1Q won't I be able to get to the access points if their management IP is on ...
Thank you for that, that works perfectly. Just out of interest do you know whether the 3500 series support LACP with regards to etherchannel, or was that introduced in a much later ios?
Thanks for that. So say I'm using 3 subnets(192.168.10.0, 192.168.20.0,192.168.30.0) and i've created 3 vlans (10,20,30). Would I then create 3 DHCP pools on the 3750 and assign the IP helper address to each vlan to be the management ip of the 3750? ...
