About frederick.w.moore

frederick.w.moore · 10-30-2008

I have a 4506 and a 6509 with a 4 gig etherchannel between them. The interfaces are trunked. I am not able to get more than 1 gig of unidirectional throughput between them. I have tried Smartbits and iperf. Any suggestions as to the cause?

frederick.w.moore · 08-19-2008

Using LMS 3.0.1. Is there anyway to customize the initial login screen? We would like to put a banner on it similar to what is displayed when logging into a switch. Thank you.

frederick.w.moore · 07-02-2008

Can the USB port on a Sup720 be used for anything else other than a USB stick? What is Cisco's future plans on switching to USB for console access?

frederick.w.moore · 03-06-2008

We are in the planning stages of switching from a Windows platform to Solaris for LMS 3.0. What would be the optimal hardware specs for a 10,000 node system? If you have model numbers that would be great. Is it better to use a T1/2 processor or sh...

frederick.w.moore · 02-29-2008

Does anyone know what's the recommended partition setup for a new install of LMS 3.0 on Solaris 10? I plan on using a SunBlade 2500 with a hard drive of around 300 gig. Thanks in advance for your help.

frederick.w.moore · 10-31-2008

All of the servers are in the same vlan. I am unclear on one concept. Does the etherchannel on the 4506 running IOS combine the individual bandwidths or is the etherchannel just for load balancing? Rereading the document you sent the link for, it's...

frederick.w.moore · 10-31-2008

Thank you both for the answers. I have a concern about a note in the link that Jon provided. It says: "Note: Even if bundling four links forms the EtherChannel, the switch only uses two of them in order to transmit the data traffic. The other two l...

frederick.w.moore · 10-15-2008

Is there a Solaris version available?

frederick.w.moore · 02-13-2008

I was told by TAC that LMS 3.0 is 32-bit and LMS 3.0.1 (Dec 2007 update) is 64-bit. You first install 3.0 on 2003 Sever 64-bit and then immediately install the Dec 2007 update. Then you can run the program.

frederick.w.moore · 01-23-2008

Do you know off hand what the RFC number is? Thanks.

Member Since	‎09-11-2007 09:55 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	13

User Statistics

User Activity

Etherchannel Issue

CiscoWorks Login Screen

Sup720 USB ports

LMS 3.0 Solaris Hardware Requirements

LMS 3.0 Solaris Installation

Re: Etherchannel Issue

Re: Etherchannel Issue

Re: Broken "Now Available! CiscoWorks LMS 3.1 With HUM 1.1"

Re: Is CiscoWorks LMS 3.0 64 bits?

Re: Auto Negotiation - Yes or No?