Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to set a collector between my C3845-IPbase-mz.124-3i router and one of my branches, the problem is I dont have my 3845 in source list it is just appear in the target devices ? but I want to set it as a source device !!is it due to IOS version...
We have created more than 255 Vlans during last 5 years, and we know that eye-catching part of which are unused, I took a report from campus manager searching for Port Attributes to find out which port is assigned to a specific Vlanbut as long as th...
my company just ordered fornew LMS release and exactly needed the support to open TAC's .I searched but couldn't find the part number for this, some one send me this part number CON-PSUS-LMS410K9, I searched but I could not find anything usefull, it ...
we have more than 200 routers in our network, I have checked the Prefered Management IP option to None . after discovery was finished some devices are discovered with their lookpack address some of them with their FastEthernet0/1 address !!I would l...
Yes ! I am pretty much sure that the SNMP configuration is correct .I dont know why it is not listed in the source devices while it is on target devices !!as you may see (one the snapshot I have attached) the device I am talking about is 192.168.243...
Finally I found the reason why my devices are in included devices ;it was very simple because I have too many same hostnames, I changed the hostname to be unique and it still have those devices in the included !!! after every changing we you to rei...
Finally I found the reason why my devices are in included devices ;it was very simple because I have too many same hostnames, I changed the hostname to be unique and it still have those devices in the included !!! after every changing we you to rei...
