hkupper
Level 1
Level 1
Member since ‎01-18-2011
‎08-18-2017

User Statistics

  • 36 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Discussion Posts
30 Discussion Posts
20 Discussion Posts
First Discussion
First Question
10 Discussion Posts
1 Reply
20 Replies
10 Replies
5 Replies

User Activity

Hello,we have over 100 AP1242 with c1240-k9w8-mx.124-23c.JA2 image, tow 5508 controller and WCS running. After the ap reboots, the duplex settings of the fa0 interface change to half duplex. I have to set it manually to full duplex. In my WCS or with...
Hi,LMS 4.0 shows "could not detect SSH protocols running on the device. Failed to fetch config using SCP.Connection timed out: connect Verify SCP is enabled or not."SSH and SCP are enabled on all of our switches. On some switches it works on other no...
Hi,on my c2960s-24-TS-L switch I have configured aaa, ssh and a user with privilege 15. When I open a ssh connection to the switch and login as the privileged user, I am not in the enable mode. On my 2960G switches it still functioning.Best regards,H...
Hi all,I have setup an oeap 600 and it joins the primary controller 5508. The corporate SSIDs are showed in the wlan client but the client cannot connect to the SSID.The event_log from the oeap shows:*Dec 15 16:14:30.807: ADD_MOBILE from WLC,wmeEnabl...
Hi,LMS 4.0.1 istalled. If a device fault occours and I click on the error then the DFM shows "sorry, an error occoured".Any ideas?Regards, Hubert
Community Statistics
Member Since ‎01-18-2011 02:16 AM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 36