I understand what you're saying but I dont think that applies, we're not trying to spoof, just trying to get the originating caller ID to the end point of the call. this seems liek a setting issue either ISDN or something in CUCM that I shoudl be able to change to get the originating caller id to the final leg of the call.
... View more
Unfortunaltey I cannot turn on the debugging as these are maxed out 3845 gateways that bog down and have trouble when we trun on debuggin, plus we have our PSTN conections spread out across many different gateways so I'd have to set up a specific route for the number to capture what is needed. Currenlty we see "restricted" come up on the caller id. call flow is: PSTN call to Cisco IP phone that is forwarded to a PSTN phone.. say a cell phone... the call forwarding works but the caller ID says restricted. any tips for the config?
... View more
We are running CUCM 7.1 (3) we have mixture of phones. 79XX & 69XX The issue is when we Call forward all calls either from the phone itself or CUCM Admin to a PSTN number the Caller ID is presented as restricted. on the DN the four bottom boxes are checked Forwarded Call Information Display on Device SEPXXXXXXXXXXXX Caller Name Caller Number Redirected Number Dialed Number On my PSTN (MGCP) gateways the PRI's are configured as below, is there somethign on these that I should change to get the originating caller's caller id to come through?
... View more
.jpg "VIP Mentor"){kind=icon}
