Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got two 3750X switches that were built from a fairly basic template from my existing 3750/3560 switches. However, these new switches ONLY prompt for the device/enable passwords instead of the configured local username/password when connecting by...
Greetings!I have UCM 7.1.5.35900-7 installed running firmware version 1.4.5.3 on my 7921 and 7925 wireless phones.Since updating, an issue has appeared in which the 7921's will switch to docking mode when placed on our charging cradles (expected, of ...
Greetings! I am looking for some help with configuring a rather extensive DMVPN setup over WAN with some basic QoS policies to improve voice call quality for remote phones. I know there's some technical hurdles to overcome and some gotchas being over...
I've begun implementing FlexConnect in my environment. So far, so good... everything is working mostly as expected.However, I now have a number of devices... certain smartphones so far... that will NOT connect to a FlexConnect AP if it's a 1262AGN AP...
Greetings!For 3 years now, I've been using an NME-AIR-WLC25 controller with an ever-increasing number of AP's (reaching the 25 limit a few months ago). As part of a new construction project, I'm adding 5 more AP's onto my network. As a result, I purc...
That's great news, but it's been over a month now and no sign of this update being available. Is there an ETA on this? Can TAC issue it through a support case?
Well that's good to hear. At least I can expect some results when it gets released. The TAC person I had been working with hasn't responded to me in two weeks, so I'm a bit angry about the matter.
Well this is interesting... I tried to downgrade my firmware versions to 1.4.4.3 and 1.4.3SR1.2, and the issue persisted on my HW 2.6 test phone. However, when I did a factory reset (Settings > Phone Settings > **2 > Yes), the issue disappeared again...