Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,We recently migrated from Windows IAS to Cisco ACS 5.2.0.26 for our wireless authentication and use PEAP MSCHAPv2 hitting AD. Everything seems to be working correctly except when a user account has a restriction on which machines they are a...
Greetings,We are running a CM 6.1.2.1000-13 BE system and just started seeing the "High Traffic Try Again Later" message appear on the display of a few phones. In one case the call was dropped as well. Checked all the logs on CM as well as voice gate...
Greetings,We have setup 2 remote message notifications, one on Text Pager 1 and the other on Test Pager 2. The one on Text Pager one is set to send initial notification without delay and repeat every 5 minutes. The notification for Text Pager 2 is se...
Greetings,I have a 2821 router with 2 VWIC-2MFT-T1 cards that have 3 point-to-point circuits and a CAS voice T1 connected to them. I would like the 3 data Ts to get their timing from the line. However when this is done I get timing slips. I would r...
Hi, the current situation is that we have 2 sites that each have 2811 routers and incoming PSTN lines. The sites are connected via a T1. Site 1 has an AIM-CUE that the calls from the PSTN at Site 1 and Site 2 are directed to for AA. In this scenari...
Yep, that looks like the issue. We are running Cisco Unity 5.0 Build 5.0(1). It's hard to tell from the bug whether it is an issue in Unity 5, do you know? And if so there is no stated fix until 7. Thank you for the quick reply.Rob
