Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are using catalyst 3550 100BaseFX and fiber power injector to connect to AP1240.We have also configured station-role root fallback shutdown so when ethernet goes down it also does Radio interface but this is not working.Does the power injector ...
I would like to use this Hw platform with OSPF but all the releases I found refer to SUP III or SUP IV (12.2(20) and above).Is it possible ?Example :http://www.cisco.com/en/US/partner/products/hw/switches/ps4324/prod_bulletin0900aecd8015f3db.html
Hi,I have a gigastack configuration where the C2900XL have the "Keepalive not set" by default. Other C2950 have "keepalive 10 sec", all the interfaces are switchports configured as trunksThe Gigabit ethernet of C2950 go to "err-disable" status becas...
Actually, the ap ethernet never goes down because when the switch goes down there is not link loss propagation from its interface (100BaseFX) to the ap ethernet interface (100BaseTX) through the transceiver.We are planning to test HOT Standby using I...
Hi,I'm currently using 2950 and 3550, do you mean although it appears it doesn't work ?And do you know when it is suitable to use ? I haven't found any information about itThank you very much
Thank you all for the information, I thought that even the ACL doesn't exist there was an implicit deny.The configuration is being arranged and all is in place, thank you
Hi,I've measured it in normal operation, there are 10 servers using broadcast to talk each other, but they carry a lot of traffic. Here you can see the statistics of the interface vlan.I supposed we are going to separate it from the main vlan. Hardw...
