Actually, the ap ethernet never goes down because when the switch goes down there is not link loss propagation from its interface (100BaseFX) to the ap ethernet interface (100BaseTX) through the transceiver.
We are planning to test HOT Standby using IAPP queries but although the stanby ap will detect the link loss, from the point of view of master ap it will look like that standby ap is down so we don't know how it will work... any suggestion ?
interface Dot11Radio1
no ip address
no ip route-cache
!
encryption vlan 721 mode ciphers tkip
!
ssid QSSQ
!
speed basic-6.0 9.0 basic-12.0 18.0 basic-24.0 36.0 48.0 54.0
power local 17
power client 17
station-role root fallback shutdown
beacon period 98
no dot11 extension aironet
dot11 extension power native
!
interface Dot11Radio1.721
encapsulation dot1Q 721
no ip route-cache
bridge-group 255
bridge-group 255 subscriber-loop-control
bridge-group 255 block-unknown-source
no bridge-group 255 source-learning
no bridge-group 255 unicast-flooding
bridge-group 255 spanning-disabled
!
interface FastEthernet0
no ip address
no ip route-cache
duplex auto
speed auto
hold-queue 160 in
!
interface FastEthernet0.721
encapsulation dot1Q 721
no ip route-cache
bridge-group 255
no bridge-group 255 source-learning
bridge-group 255 spanning-disabled
!
Thank you for your attention
