Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I simply need to see a list of all IPs using a Cisco 2800 series router. I know I can run a show lldp command on my switches to get a list of attached devices, and I know this is a layer2 command. Is there any way to get a list of IPs that are usi...
[I hope I got the right forum area]We use a mitel 3300 PBX for all our VoIP, across mostly procurve equipment, but Cisco too. All runs great, except at our biggest branch office, which connects via a 100mb metro-E. The telco hands this metro-E to u...
I am setting up my 2nd 1811 router for NAT and VPN. The 1st 1811 works great, completed a few months ago. On this 2nd 1811, I decided to just copy the working startup-config from the good, 1st router to this 2nd, and then change IPs and from there....
I have a router I'm setting up for a branch office. I got NAT and VPN working. All good. DHCP is failing me though.Here's what I added to make the router do DHCP:no ip dhcp use vrf connectedip dhcp excluded-address 172.16.31.1 172.16.31.9!ip dhcp ...
I can ping and NAT is working. I've built the phase 1 and 2, the ACL several times using access-list and ip access-list extended and double-checked both routers.Other than that, "show crypto isakmp sa" just gives:"IPv4 Crypto ISAKMP SAdst ...
We have fixed this problem by hard setting the line speed and duplexing between the procurve switch and the pbx. We had it set everywhere else but there. Again, only our 100mb site had any issues out of many sites, and setting this final interface ...
I want to add that the problem description provided in the link -- that discusses the fix being fast start with h.323 -- is the _exact_ same issue I am having.
You are correct about the link and H.323.I did simply find a same-word command with Procurve, and it does have a default delay approx. to the delay we are experiencing -- 5 seconds. I changed this to 1 second.Edit: short of it: that links discusses ...
I have tagged my original post.I have also found the document for my specific router(s) regarding changing/upgrading image files. I was shocked to read this:"If the total memory is less than the new system image's minimum flash requirements, you mus...
Good stuff. I guess I only paid attention to the first sentence in the following:"This document is not restricted to specific software and hardware versions. The platforms used for the purpose of this document are Cisco 2500 series routers and Cisco...
