Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to setup a template to check and deploy a configuration change based upon the following criteria
All Switches, any fastethernet or gigaethernet interface with a interface description containing the string "PC" should have the command "no s...
Hi there,I have a situation that I am trying to solve. We have lot of services trough ACE, but now I have to modify one of them, PROXY servers. I have six (6) servers working with Sticky, but with a MASK 255.255.255.0, which produce an unbalanced sit...
Hi, I have problems about backgrounds on IP Communicator and 7970, 7971. I followed the steps:http://www.cisco.com/en/US/customer/products/sw/voicesw/ps5475/products_administration_guide_chapter09186a00805f085b.htmlbut, I can't make it works. Any ide...
You are right Madison, I was recently trying to do un upgrade at this old NAM card, and I had this issue. Sadly, I could not find in my serach a relation of this error with the procedure needed to solve it.
The problem with upgrading this card, is th...
Hello Emre,
I´m sure you already solved this issue, I was looking a solution to this problem and found your post, sadly there was not resolution. But found a document with information needed to solve your original question, here is an example extrac...
Thanks Inayath, it was very helpfull !!!I started with step 4, and the result was very complex, but finally show me too many flood packets to the RP.Step 3 showed me the problem, good convination of filters.RegardsAlexis
Hi, I´m having same problem, but we are working with 2.1 (2.1.0.0.87) version. I can create new domain, but the TABs never shows any component, no matter which TAB I chosse. Have do you solved this problem ? RegardsAlexis