Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an a WLC 4402 version 7.0.230.0 with AP's (1130's) running in local mode with a bunch of remote sites. All wireless traffic is sent through the controller at another remote site. I have MPLS with VPN failover. When it goes to VPN it works fine...
I have a customer with a bunch of these sup modules. I notices soema re running regular IOS sfw and a few are running an "rp" version. I also noticed some of these have seperate mfcs3 sfw (c6mfsc3) in bootflash and the image s72033 in sup-bootflash. ...
I have a 6513 with two 4K watt supplies and two 720 sups (12.2(18)SXF16) a customer just brought used. I'm having modules shutdown due to insufficient power. Also the power supplies leds indicate ok but no part number when I do a shpw power I get thi...
I have a webserver that that has a portmapping from the outside x.x.x.x port 80 to a dmz address y.y.y.y port 82. Works fine. I want to have the outside x.x.x.x port 80 mapped also to a dmz address v.v.v.v port 83 when x.x.x.x is taken down to displa...
Is there a way to have the ifAlias (interface description) sent with a linkup/dwon trap from a 3750 switch? I want the info for alerting with What's Up Gold.
Thanks. In this case with OSPF from a bonded T1, what would be wise default metrics to use for EIGRP. EIGRP is mostly runnung on a L3 switched infastructure. Thanks
Can I have 2 (set ip next-hop x.x.x.x) statements or something simular, say one with a higher cost. You see, if the preferred route is down I want it to goto to another with a higher cost in a route map.
