Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Attempting to switch to updated version to address software bugs, however when trying to switch from the active to the inactive partition I receive that following output via CLI: Waiting ..................................................................
Using CUCM 9.1Is there a quick and easy way to create a hunt group type set up using outside (cell phone numbers)?The scenario will be one (person who will be ON Call) using an internal DID that is forwarded to to a cell phone of the oncall person th...
UserIDs are not being resolved by Domain Controller agents installed on PDC or BDC. Trend shows the domain controller agents connected successfully, but when adding users by name the filtering policies are not applied. Is there a...
Hello,Using CUCM 9.1 and recently received a replacement 7940G phone back from Cisco. However, when it attempts to boot it stops and reports "tftp file not found". I have read that this could be related to a firmware issue, but how do I tell what ...
Recently upgraded to CUCM 9.1 and I'm new to Presence and Jabber. From what I can tell most of the configuration is done on the Call Manager side now but I'm still confused whether I need a standalone CUPS server and how to tell if I can actually se...
Thanks to everyone for the suggestions. Ultimately had to build an upgraded 10 box and cobras everything over to get around the bugs. Things are working once again
Unfortunately everything went well until the end when the db was being loaded:06/23/2014 18:41:57 06_load-database|Depending on the server specifications and on the level of activity on the system, this may take up to an hour.|<LVL::Info>[Fatal Error...
Jesse, Thanks, I have a ticket open with TAC and they have been troubleshooting for a while now. Now they suggested simply moving to a more recent update/patch. However, if this doesn't work I will definitely be trying your suggestion next. This h...
Thanks George, after pasting all of this and taking a moment, I now see that the vendor applied a restricted version perhaps. Going to try uploading the restricted instead and see how that goes.
