Hello- I'm trying to use DayN template to configure switch port. All the vlans are created using Onboarding templates.So in the config i have following vlans already provisioned on the switchvlan 30name VOICE-VLAN!vlan 40name DATA-VLAN! so in my DayN...
Is there a way to use DNAC to audit configs either Manually or Automated way. Basically if the config doesn't match the template, i'd like to find out what's changed, when and by who. This is for non sd-access mode switches. TIA
Hello- We have a setup where each site as dual cEdges and each cEdge has a DIA link. I would like to use cEdge1 for all internet access i.e google.com and only use 2nd link in case the first link is down. Is there a way to perform link failure detect...
looking for something similar to junipers
set policy-options prefix-list local-router-ipv4 apply-path "interfaces <*> unit <*> family inet address <*>"
that way i don't have to actually specify local IPs. Is there something similar in cisco ios/x...
Hi- I have a need to connect 2 VRFs across two 9508s. Switches are connected via a L3 connection and can't be converted to L2 trunk. I was thinking about using GRE where tunnel is member of the VRF and uses default vrf to set up the tunnel. This isn'...
unfortunately this is a legacy environment and not easy to clean up . I only found interface.vlanid in the variable ..thats not what i need. will just have to input the vlan id for now until we figure out another way.. thank you
Thanks Markus- What i need is to look up vlan ID somehow as the ID could be different every time. I need something like i.e {% set VoiceVlanID = 'sh vlan name VOICE-VLAN ifindex ' %}obviously this doesn't work but you get what i'm trying to do here
i do have different Onboarding templates which configures different vlan IDs. i was hoping to use single DayN template to configure the ports with different vlans
if i use lo0 on switch1 as the source of the tunnel and lo0 on switch2 as the destination, those loopbacks are in default vrf...so tunnel comes up fine but i need the tunnel to a member of a non default VRF.. i can't use interface that are in the def...
