Hello! I have a question related to in which switch I have to configure static routes. I have different FW connected to different ACI switches showed in diagram. I have to configure default route to upstream FW and inside route to downstream FW. Need...
Good morning, I want to deploy the EVPN Multisite back-2-back and in design guide the minimum connectivity required is square but recommended full mesh between BGW located in different sites. What exactly will I lose if stay with square design becaus...
Hello,We just implemented mvpn for ipv4 traffic in ASR9K successfully but now we need same thing for ipv6. After doing all configuration we saw type 1 and type 7 route propagated and control plane looks ok but we don’t receive any traffic. Look like ...
Hello,I am trying to configure next-generation multicast between Juniper and Cisco IOS XR according to book "MPLS in the SDN era" page 200-240 and question I have is how QoS is supported in this type of traffic? Can we prioritized over another type o...
Hello, I need any help with where can I obtain VM or files for CloudCenter 5.0 for AWS and how can I install it there?Any link or information will be appreciate.Thanks,
hello, can you please share the configuration of DB because I have the same issue? is it portgre standalone? In CCM you use name of Postgre DB insteed of IP or name of CCM ? thanks,
I have two nexus Border Leaf conected via EBGP to 2 PEs. Every nexus has aggregate-routes for fabric IP configured in bgp and redistribute direct inside the BGP too. The problem is that in one Nexus I see not only agrregate route pointing to null but...
hello,from document it´s not clear what type of route are direct route. For me aggregate routes pointing to null 0 are static routes and not direct routes.regards,