About IT-LDI

IT-LDI · 04-30-2021

Did you ever find out a resolution to your problem? I'm not sure if the problem I'm having is the ex...

IT-LDI · 04-29-2021

I have recently setup the Cisco Terminal Services Agent on our terminal server to allow for individu...

IT-LDI · 04-11-2021

I set the NTP time back to the PDC and the Cisco Terminal Services Agent seems to be working fine. I...

IT-LDI · 04-10-2021

I currently have the Cisco Terminal Services Agent running on our Terminal Server 2019 and configure...

IT-LDI · 08-26-2020

In our network we have our Router, DC, DNS, DHCP, server setup. Our DHCP is currently setup using 10...

IT-LDI · 08-24-2020

Here's what it shows for the Flexconnect WAP2#sh capwap reap statusVLAN - root hwidb:GigabitEthernet...

IT-LDI · 08-22-2020

Thanks Scott, I will try using the DHCP server instead of having the Controller be the DHCP server, ...

IT-LDI · 08-21-2020

The controller is built into the Cisco 3650 switch via WLC local.

IT-LDI · 08-21-2020

These access points are setup for Lightweight mode and not autonomous. And yes we have no problems w...

IT-LDI · 08-21-2020

I see that the Dot11-Phone Mode for out 7920 phones is showing that it's invalid. We are having some...

IT-LDI · 08-21-2020

I currently have 7 2602i access points connected to 5 different 6530 switches. If I take a new lapto...

IT-LDI · 08-19-2020

I have (7) Cisco 2602i lightweight access points that are connected to (4) different 3650 switches a...

IT-LDI · 08-11-2020

Looking at (1) of our locations router configuration, I did find where the scope entries were and cr...

IT-LDI · 08-10-2020

I was able to change the switch configuration that the controller was setup on and make it an agent ...

IT-LDI · 08-04-2020

I see that is not possible to create an existing scope within the same network and it mus be in its ...

Re: Users failed to login to TS agent and Terminal server network connection loss after installing TS agent?