I am working on creating a voice vlan for our Cisco WLC that I have had setup and working well the past few years. We currently have some wirless 8821 phones and I want to create a separate vlan for this. Currently they are running on a layer 2 vlan ...
I'm working on setting up a vlan and need to use SVI along with this. I'm having trouble figuring out what IP address is assigned to this.Is this an IP address of an existing device, or would this be an IP that I would assign? Thank you,
Hello, I need to setup a vlan that I can use for Layer 3 on our wireless controller that is built into our Cisco 3650 switches. I do have the wireless setup on the controller working for the past few years without issues for the wireless data and gue...
I currenly have the WLC setup on our switches for our network and it's working fine for the laptops and other wireless devices. We just got a new Cisco phone system put in which replaced the outdated Cisco phone system. Along with that we also have t...
Hi, I have followed the Cisco instructions on setting this up within Cisco Firepower Management Center version 6.4.0.4 (build 34). The Cisco FMC is showing all of the clients correctly and where they are going so the information I'm getting is all go...
When configuring the VLAN on the other switch ports, would same IP be used? w-5760-3(config-if)#ip address 10.1.1.1 255.255.255.0 ( make sure there is no overlap address in your network)
Thank you for the information. This gives me the direction to take on this.For the wirless clients that were connecting to the access points via the vlan they are using for the DATA, will this switchport still provide the wireless connection for Laye...
I see that doesn't seem to work since the WLC Wlan doesn't see the access point anymore. I will give it a try with the IP address configuration for our network since the phones are able to see this IP network.