I have a Cisco 3945 with cucme. When attempting to add a 7942 phone I receive the TFTP error "Sending error 1 No such file". When researching it seems that I might need an intermediate firmware update. Here is the tftp debug output:
.Nov 14 09:51:5...
Hello,
I have been working with Cisco gear for a few years, and I currently manage a statewide network with over 800 routers. I also manage the ASA's, Firepower, ISE, and Stealthwatch amongst other things on this network. I am not an expert at anyt...
I have 4 sites that are connected to each other over WAN links. The interface speeds are 100 Mbps, but the Wan link is only 20 Mbps. The sites do not have ip phones, but they are getting one Avaya control unit at each site. These control units will c...
Yes the L2 network is multipoint with all WAN interfaces on the same network. All of these sites are L2 to the provider which gets handed off to my POP at L2 to be filtered and firewalled before they hit the internet. A couple of the sites max out th...
Thanks for the tip on shaping. I attached a diagram of the network.
The reason I want to do Qos is for the Avaya Units to get priority when communicating with each other over the Wan links.
Thank you for the example.
Would the traffic from my Avaya control unit probably already be tagged with a dscp value? If so, is this something I need to tell my router to trust, and if not is it something I would need to match the traffic type to a d...
