Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Is it possible to have simultanious dial in and dial out connection on the same ISDN BRI? I suppose there are some limitations with the signaling but would like to verify with the forumThksVelimir
Hi,Let's say I have my system connected to two bgp peers. The best path is always through one of the peers. Having in mind that BGP can only load share and not load balance will the link to the second bgp peer (that normally has no traffic) pick up...
Hi, There might be a conversation like this somewhere on the forum but I could not find it.My question is, in you own oppinion what is better AAA for basic ISP services, RADIUS or TACACS+ ?There are many pros/cons for both so I just want to hear yo...
Hi,I would like to know if it is possible to configure the inside interface of pix 506 E with two addresses. One would serve for the LAN and the other would act as DMZ since the pix 506E has no DMZ port. Can this be done, is there a better way to d...
Hi,Lets say that client uses serial line connection to the central office and ISDN backup call in case of serial failiure. What very often happens is that the ISDN is not functioning or has stoped functionig on the telco side but since the serial li...
Thanks for your resopnse.I searched all over Cisco's site and could not find any sample config on this problem. Do you have any suggestions?RegardsVelimir
One more thing. From what I know, RADIUS sends username/password over the wire in encrypted form, (what I suppose is better), TACACS does not encrypt this info. With R you can also check the CallerID and some other nice things, what you would have ...
