Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently on ACS 5.2 and our MS Active Directory is migrating to a completely new domain. There will be a two way trust between them for the 24 month migration period. Any advice on how best to configure ACS connect to both domains? Anyone gone thru ...
I have recently installed at PIX 501 (latest version 6.3(4)) on my home office network.Most everything works, except.. I have issue where a Cisco VPN client 4.0.2(D) can't connect outside to a VPN concentrator. It initial IPSec tunnel is established,...
I just installed a wireless site with 1131s. When connecting to an access point, getting a lease, then moving to another office, the lease is lost and the Windows XP defaults are used. All access points are configured the same and with the same IOS v...
I created a rule to allow stupdate.exe from the *\program files\trend\sprotect\*\ and all of its sub processes and added it to my policy, yet it still does not allow Trend to update.Anyone have a similar situation that could shed some light on this?T...
Can one use port security (limit the learned MACs)on a Cat 3500/3550/4000 to stop users from connecting a wireless access point?If yes, will the first client on the access point be blocked? What is the command syntax?Ted
!6.8W is full power for a 3702 AP, so 4x4 mode.The question I have is how to suppress/stop the alerts in Cisco Prime? We know the 15.4 is not full power, but have not had the chance to replace the older switches.
I am seeing what could be the same problem on a six switch 3750 stack running 12.2(52)SE IP Base. Replaced a stack cable with a brand new one, but still stuck in 16G mode and stack neighbors are up/down, changing every few seconds. Opening a TAC cas...
No special software needed. You should be able to get to the PIX Device Manager (PDM) with your browser, using https://[inside interface I.P.].Other access types should be available as well, but it will depend on what is enabled and from what interfa...
Figured out the problem. The shared key with the RADIUS server was not the same on both sides. It was correct on the one access point, but not the others. I used WLSE to load the configs on the rest, which was the real problem.Thanks.
