Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
I've the following scenario:
2x5548UP Nexus devices with interfaces Eth1/1,Eth2/1 as member of Po1 (vPC Peer-link) and using mgmt0 interfaces on both devices for the vPC Peer-keepalive. Nexus don´t have L3 daughter card.
-----------...
Hi Community, Suppose the following scenario: (SVI Vlan X )--- 3750----------L3 link ------6509--------L3 link-------6513------(L2 only Vlan X) ¿Can I use L2 over GRE in order to tunnel VlanX so that I can have one SVI on one end and layer 2 Vlan on...
Hello community,I would like to know what is the maximum number of FEX devices that can be connected (straight through according to supported FEX topologies) to a pair of Nexus 7k with sup2 forming a vPC domain?. I know that for 1 Nexus 7K it will su...
Hello There, my best wishes to all of you.I have this scenario:ServerA(FTP)----DMZ-------ASA_Site1-----------------------Cloud---------------------------Checkpoint1_Site2-------Checkpoint2_Site2---------Inside-----ServerB(FTP)We are trying to establi...
Hello everybody, first of all, my best wishes to all of you this Christmas.Ok, I have the following scenario. A Cisco ISR 2811 with CME 7.1 and IOS 12.24T working with third party SIP phones. The IP phones can call each other, can make and receive ca...
Hello Jeestrad,
Thanks for taking part of your time for replyin to this case. Ok, I understand your proposal.
I just wanted to avoid that kind of topology for vPC peer-keepalive thinking that it might cause some issue to send that heartbeat traffic...
Hi Joseph!Thanks for your reply. How could that be?. I´ve never mixed a layer 2 trunk over a SVI. Could you please give an example o refer me to a link?Regards,
Wow, that was more than I expected for an answer. Thanks. Ok, now my turn to answer your questions:0- On the ASA, yes, I terminate VPN clients for remote access. I didn´t know this could be an issue. I will take into account your suggestion, i will t...
An additional question and sorry for that.It is possible to use the an OTDR in the monitor port of the CWDM-MUX-8A in a production environment without affecting service? Thats something i´m not sure about and i would like to clarify as an alternative...
