Hi All,
I am trying to stack 2960x "WS-C2960X-48LPD-L" switches in two different racks, and racks are far away from each other. ( lets say 4 Meters distance between racks).
My ask is, how I can create stack between switches using fiber cable (100...
Hi There,
Can anyone tell me how to make default port in Cisco Data Center 5K Switch?
When I do show run int e2/10 [the output shows as follows]
switch(config-if)#
medium p2p
This interface has been changed into L3, I have tried to bring it back ...
Dear Expert, I am getting following error during installation of LMS 4.0. ( "CWLMS-4.0-100-K9").I have installed SP1 for the Windows 2008 Standard R2, still getting same error. Since Cisco's minimum requirement is Windows 2008 Standard and Enterpris...
Thanks Rex's for your reply,
I don't have enough uplinks in core so can't make them separate stack.
and the longest stack cable cisco has 3 meter which is no not enough for me as well that's why trying to do it with fiber.
plz let me know if you fi...
Hi Mark I found this solution.
Can you try at your end and confirm if it works, I dn't have any empty port to test in my production switch.
Usage Guidelines
When the system default switchport shutdown command is issued, any switchports (including ...
