Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi:Is it possible to reset a C927 router with the hardware reset button and cause it to load a configuration file on flash or nvram with a name such as cpconfig-9xx.cfg ? This method works fine with the 800 series router using the file cpconfig-8xx.c...
Hi:I have a timer watchdog script that runs once a day to evaluate whether there is dialtone on the phone line attached to an external modem on aux 0.I have no problems with the script if Tcl cli debugging is disabled, but as soon as I enable 'event ...
Hi:I have DMVPN peers set to use RSA signatures for setting up IKE phase 1.Is it possible to get the certificate common name (CN=) to show up in AAA accounting records?I have not been able to find the appropriate PKI AAA commands to do this.Currently...
Hi:The command documenation is very limited:http://www.cisco.com/en/US/docs/ios-xml/ios/interface/command/ir-t2.html#wp1398569350Can someone explain what this command is really supposed to do?If I set it on the Tunnel interface which has a known dest...
Hi:I've set the SNMP Trusted IP to be a single host (i.e.: 32 bit mask) and I can still access the SPA122 SNMP agent from other IP addresses which should not be the case.Has anyone else seen this behavior?Model:SPA122, LAN, 2 FXSHardware Version:1.0....
Adding some info I learned.A file ending with .cfg on a USB drive plugged into the router when it is powered up will in fact be copied from the USB drive into startup-config and onto flash: and nvram: Once you have a startup-config loaded, the RESET ...
Thanks for the reply. That seems to fix my problem.I find it odd though as my term length was 24 and there was not 24 lines displayed before the --More-- prompt.
Thanks, authentication is already working. My question is about getting accounting records with the certificate CN showing up as the user-name in the accounting start record.
