Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Since recently we've decided to add some redundancy links in our network. So, now the network looks like this: As you can see we've got catalyst 45XX and 65XX switches and asr9k and asr1k routers in the core level. In the access level we use Dlin...
Hi,
I've got a cisco 6500 switch and dot1q trunk on one of its ports. But sometimes I face with storm on some vlan on the trunk. And I still can't find any useful way to detect which of vlans storms my switch. Of course, I can check all counters on...
Hello,
Could anybody explain me about sh policy-map control-plane command on c6500? I'm implementing CoPP on my cisco switch. I've created ACLs, class-maps and policy. After that, I entered sh policy-map control-plane CLI command:
#sh policy-map con...
Hello!
I have configured this scheme:
| c6500 |g4/47|------[trunk - 300 Mb/s MAX]------|g0/0/3| ASR1002f |
After that, I saw that "Input errors" counter increased on the c6500 - g4/47. The g0/0/3 on the ASR looks without problem. What's more, packet ...
We have cisco wlc 2125 with 13 AP 1131g. All works good. But after power failure one AP can not join to controller, only reset help to recover connection AP to WLC. Additionally, we don't have access to rs-232 port on AP. In this moment on WLC we can...
So, I've tried to apply QoS policy on service. it works, service has been applied:SERVICE-TEST Auth-Type := Accept
User-Password == "cisco",
Cisco-AVPair += "ip:sub-qos-policy-in=isgPolicy",
Cisco-AVPair += "ip:sub-qos-policy-out=isgPo...
Hello!I have the similar problem, so I've decided to ask it here. I'm working on ISG configuration on ASR 1001x. It works OK, but I need to add a lot of new services with DSCP policies, like this:policy-map 50m
class class-default
police cir 51200...
Thank you very mutch for "top report" command. I didn't know about it before. Unfortunately, it can be used for physical interfaces only. I'm going to write a script which will get information about vlans via SNMP and show me report
Thank you very ...
Thank you for your reply! I forgot to write, I had configured strom control on physical port. And I sometimes see messages in logs: "%PM_PLATFORM-5-PORTDROP: Port GigabitEthernet3/6 dropped packets due to storm control". But I need to detect flooding...
