Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am using LMS version 3.2 and i am not able to generate EOS/EOL report with error no connection to Cisco.Saw an update i LMS portal as this:Now Available! LMS 3.2:Patch for un-interrupted service of Cisco.com download for Device/Software/PSIRT/EO...
Hi,I an doing device discovery and get the result as devices are unreachable and only 1 device among them getting discovered.Any inputs????Screen shot attached......ThanksRichard
Dear All,My 7206 router is running the ios c7200-a3jk9s-mz.124-25b.bin and the same support the configuration mgcp behavior g729-variants static-ptWhen I upgrade the image to c7200-adventerprisek9_sna-mz.124-4.T7.bin its not supporting the above comm...
Hi,I am experiencing high memory utilisation on my 2950 switch. CPU is normal. I am not able to get a clue how to get it reduced. I am attaching some of the output here and eager to get a solution for this...Thanks Richard
Hi,We were changing the L2 switches from VTP client to transparent mode. But after changing the same, it could observe that we are not able to access the backbone, but was able to access the onsite project.Backbone access is going through firewall an...
Hi Afroj, I have set the fetch interval to 1 hr and 7 days also. But the job status continuous to be running, its not wind up in pass or fail and i am not receiving the mail alerts.Enabled the debugging for inventry reports and collected the logs... ...
Hi,I have the atmost latest ios running and i there is no bug reported causing memory leak or memory utilization. Do you have anything to say about DTP protocol causing high cpu ? or any other idea....ThanksRichard
Hi Maxim,Thanks a lot for the input. I have pasted the sh process memory out put in cisco output interpreter and i could see the 3 procees holding more memory.'Entity MIB API' is holding 424748 bytes 'VMATM Callback' is holding 137968 bytes 'DTP P...
Hi ,After resetting the switch port the cpu utilization came down. But when the user is trying to authenticate the screen hangs for a while and throw an error % Authentication Failed.Regards,Richard
Hi Nicholas ,I am new to this product so please guide me how to check the1> Total authentication count at a particular time2> Total traffic hitting to the ACSAt the time of issue the CPU load is going to 100% even though we are able to ping the devic...
