Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I have a Nexus C93108TC-EX switch.
Software BIOS: version 07.59 NXOS: version 7.0(3)I4(5) BIOS compile time: 08/26/2016 NXOS image file is: bootflash:///nxos.7.0.3.I4.5.bin NXOS compile time: 12/23/2016 16:00:00 [12/24/2016 01:37:34]
In each QSF...
Hi
I have a ASA 5545 with version 9.4(2)11 in routed mode
And I have problems with the Global ACL.
I started with ACL's on the interfaces and that works fine. I put an ACL's on the interfaces with the lowest security and I use the ASA default that tr...
Hi We have a WS-C2960S-48TS-L switch with QoS .I have configured 1 ports and 1 trunk port.interface GigabitEthernet1/0/34descriptionswitchport access vlan 104mls qos trust dscp!interface GigabitEthernet1/0/52descriptionswitchport mode trunklogging ev...
Hi .I have 2 CISCO2901 routers with IOS Version 15.0(1)M4.In each router I have placed a HWIC-2SHDSL interface card.Now I try to make a connection SDSL between the routers, but it is not working.Even on my desk with a cable from 2 meters it will not ...
HiThe ISP give me a range of public IP spaceNetwork: 46.28.13.240 /28Gateway: 46.28.13.254Useable: 46.28.13.241-.253Mask: 255.255.255.240The ISP interface is RJ45 Ethernet.On my side is a Cisco 2811 router with only 2 Ethernet interfaces and advance-...
Hi PeterThanks for your answer.I have fixed the problem with remove the auto MLS QOS settings and configure manualy the mls QOS dscp settings on the switch. And now it works fine.You are 100 % correct about the statement of the DSCP field. Because ...
Hi markThis configuration will work or must I configure anything else ?Router 1 ip address 10.129.33.253 255.255.255.0 standby 108 ip 10.129.33.254 standby 108 priority 100 standby 108 preempt Router 2 ip address 10.129.33.252 255.255.255.0 standby 1...
HiThe problem is solved. When you use SSH on the gateway, you need to configure a DNS name on the Gateway, and that was the problem. Removing the DNS name was the solution. I have send this Bug to Cisco TAC.
