About clpaul

clpaul · 10-18-2019

I have done Stackwise virtual many times with 9500's & 9400's but they were always out of the box. The customer have 2 existing 9407R and would now like to virtualize them. I understand the priority and renumber commands to control which switch is ...

clpaul · 07-24-2018

Can I export the rules from the 5585 and import them to the 4140 or do I need to make changes to the existing rules? Thank!

clpaul · 11-07-2017

Does the new NIM 4G modules still take the same SIM card as the older EHWIC cards. I have a customer that needs to install the new NIM module in a 4331 and needs to know if they can reuse the SIM card in the old 2821 EHWIC. Thanks!

clpaul · 08-12-2016

Have a Cisco Verizon LTE with WiFi 819 router. I am having trouble getting the integrated AP to work on the router. I know you have to map the vlan etc to the AP and documentation states that it is like configuring any Autonomous Cisco AP but I can...

clpaul · 11-23-2015

Customer currently has VM cluster running software below and will be upgading to 10.5 using PCD on same hardware. I am a little confused with the various upgrade guides etc. Since this in on the same hardware do we need to deploy the OVA for t...

clpaul · 10-28-2019

As I thought the config on the primary switch stays but the interface configs are wiped due to port renaming/numbering. Had to repaste all the interface details back into the config using new port numbers

clpaul · 08-21-2016

Luke, I got it to work. I totally blew the AP config away and started over and it worked. I guess all of the changes I was making messed things up. I can send you the working configs if you like. Thanks for the help!

clpaul · 08-17-2016

I can see the SSID but can not connect. Here is the actual router and AP config. Sh ip int at bottom of each config

clpaul · 08-14-2016

Luke, I am out of town at a customer site so I can not pull the exact config from the 819. I do have vlan 1 in the 10.10.10.1/25 and the BVI interface in the AP as 10.10.10.2. Basically I can not get the radio to come up

clpaul · 11-23-2015

It would be an upgrade. The customer is currently running 9.1(2) on VMWare server (Not bare metal servers) and upgrading to 10.5. I know PCD will install the 10.5 in an inactive partition and then switch it to active after the install. I just did ...

Member Since	‎03-10-2005 04:56 AM
Date Last Visited	‎09-19-2024 03:36 AM
Posts	18
Total Helpful Votes Received	10

User Statistics

User Activity

Catalyst 9400 Stackwise Virtual

Cisco ASA 5585 to Firepower 4140

Question about Cisco 4G LTE 2.0 Network Interface Modules

Cisco 819 ISR AP configuration

CUCM Upgrade from 9.1.2 to 10.5 using PCD

Re: Catalyst 9400 Stackwise Virtual

Luke,

I can see the SSID but can

Luke,

It would be an upgrade. The