Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear
I have a technical question I want to share with you.
Recently a Cisco A901 practically stay if memory for the processor, then it will restart and generated a crash.
Below I present the output of the command "show memory free"
ASR_SSEE_CO...
Hi, everybodyRecently we ha a Nexus 7010 with a module frozen that was OIR (Online Remote and Insert) but do not work until reload the Nexus 7k.The command "show tech-support" has the following:exception information --- exception instance 64 ----Modu...
Hi, everyoneI have 3 routers connected as follow:R1 -(.34 )--(5.5.128.32/27)--(.33)- R2 ---(.2 )--(5.5.128.0/27)--(.1)--- R3 R2 have pim sparse-mode and it is the AutoRP and Mapping AgentR1 have pim-sparse-mode and the loopback interface is igmp-join...
Hi everybodyI have a router configure with pim dense mode and when I used some command to verify the operation I can see that the router show joining to multicast group 224.0.1.40. Can anybody tell me why?RA#sh ip pim interfaceAddress Interf...
Hi, everybody.What is the capacity recomendation for simultanious data users and voice calls with codec G.711 and G.729 on APs Serie 3500?I need to do a design but I do not find information about this point, In older version of APs I was to readed ...
Regards, Subhash EdirisingheThe VPNv4 route is sent to the peer and internal, as you did in redistributing the PE Router with MBGP (address-family ipv4 vrf TEST).Look at this example:BGP routing table entry for 2:2:171.1.1.1 / 32, version 5Paths: (1 ...
I really like to help, but it is critical to see the output of the command:show process cpu sorted 5secWhen a router is slow can be for many reasons, but must be sought that could be causing process disruptions CPU out of the ordinary and be able to ...
Routers that model is? could you share a show version?I recommended using the command: show process cpu | show process cpu sorted 1min | show process cpu sorted 5 secThe show process cpu history command is not very useful in this case, because what w...
When disconnecting the network router, the router responds faster?You could do the following procedure to collect information that will be useful:- Connect to the router via console- Disconnect all network ports (serial, Ethernet, etc) you have conne...
Regards, PeterThe question presents some ambiguity, however if we separate two ecenarios.1) The router must select a route for RIB table and the route is learned by various routing protocols. For example: OSPF, eBGP, iBGP.Here it is useful the follow...
