Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am planning on deploying 6 Cisco Aironet 1131 Access points and I want to make sure I'll be able to roam (SAME VLAN, SAME SSID, SAME SETTINGS) from one access point to the other without any glitch in the audio while ip phone reassociate.I've cal...
It's now an error in the title We currently rent a 10 mbps link from a provider that we use as a lan extension. The provider supports QinQ which allows us to pass all of our vlans as it it was a big crossover between our switches.There is another co...
Hi,is there an equivalent to the rate-limit command of a router interface for a 3550 switch (l2 port).Let say I don't want a device to eat more then 2 mbps of traffic...Thanks
Hi,does anyone knows if it is possible to have 2 physical interfaces from the same router to act as if it was a single one for high availability. I want these two interfaces to connect to two different switches so I don't loose connectivity in case o...
Hi,we are trying to setup a windows media 9 server (windows 2003) behind a pix firewall. We first started by opening the tcp and udp ports by Microsoft documentation ie:tcp port 1755tcp port 554udp port 1755udp port 5005The clients comming...
Hi ChristopherGDay,
I have the same problem as jlmickens but unfortunately I can't make your solution work. Could you take a look at my config and debug log to see if you find Something ?
ldap attribute-map VPNUSERSGROUP map-name memberOf IETF-Rad...
Does that mean that it is possible to configure an etherchannel between a 7206 router and two catalyst 3550 if both switches are linked together with a gigastack gbic ?Thanks
heres the answerHi, I had the same problem, here is the response I got from cisco: ~~~ hope you are doing ok, thank you very much for the info you sent me. I have been doing research and just found out that we are hitting a known issue, this is a bri...
