Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have 2 WS-C4500X-16's with enterprise services license, running IOS XE 3.4.1SG, in a VSS configuration.I have flexible netflow configured, conform to the software configuration guide, chapter 63, VSS environment.Contrary to what the configuratio...
Hi,We have Nexus 5548P switches in our datacenter. We're observing incrementing RXpause counters on several 10GE interfaces (that have flow control enabled), connected to VMware ESX hosts. We'd like to monitor the flow control counters via SNMP.I've ...
Hi there,i'm having a problem with several AP's (AIR-AP1232AG and AIR-AP1131AG) loosing their network connectivity on the Wired LAN, after some time.It does Not matter if they using Inline Power from a 3550-24PWR switchport or external power supply.I...
Hello,I'm migrating my network from existing Cat2924-XL-EN's (24x10/100baseT) to new Cat2950T-24 (Enhanced Image) switches (24x10/100baseT + 2x 1000baseT ports)On the 2924's there exists configuration commands to block unknown unicast and unknown mul...
Hi Netprofs,I'm trying to esablish a (100baseT) link between a Catalyst 2924XL-EN and a 3548XL-EN switch, with each belong to a different VTP domain (the edge between two managed networks).Note: I'm not trying to make a ISL/DOT1Q TRUNK (this would re...
Thanks Martin. I'd expect that behaviour too. But documentation (Chapter 63, Configuring Flexible netflow) clearly states otherwise.As a matter of fact, I do not see any entries in the cache of the active sup for the interfaces on the standby-switch,...
you need to add: ip helper address <ip of your cucm> to the voice vlan interface (that is, the vlan where the phones are in, not where your server is in) on your router.hth. Ed
I'm not a Windows guru, but as far as i know, Win2khas no real NTP service natively.Otherwise it should be possible to use following configuration lines to let your APs sync time with an NTP server:sntp server sntp server or, to make use of NTP broad...
Hi there,the switchports show no errors whatsoever.The AP's have no crashinfo, as they just keep running normally although isolated from the wired lan:The radio's also keep running and keep broadcasting theire SSID's. Wireless clients are still able ...
