Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I need to setup 802.1x wired with a windows 10 client and a cisco router 880.
I have a question. Can we use local AAA database a.k.a local username and password of the cisco router, for example: username cisco secret cisco as 802.1x authenticatio...
Hi guys,I have a problem when adding a map to WCS. I have a floor image file sized 1366x768. When I add this picture to the WCS, the WCS automatically convert this picture to 92.6 meter x 52 meter1366x768 --> 92.6 meter x 52 meter. My goal is to conv...
Hello Guys,We have 1 unit of 2900 series router and 3 FE interfaces. One interfaces is used as sub-interface (We have 2 IP segment that used this router as their gateway) and other 2 ports as internet link connected to router's provider.ISP give us 1...
Thanks for your reply. Yes the actual username is admin and secret admin. In my running or startup configuration already applied command dot1x system-auth-control. So full config is like this:
aaa new-model
!
!
aaa authentication dot1x default local
...
Okay sir, I read your post. But please confirm these 2 points sir:1. Switch L2 examines the L2 destination adresses, compared it to MAC address table then knows which port to forward it.2. But, the WLC is different from switch layer 2. WLC is not doi...
What? Scott from your post, are you saying that:1. The WLC is never looks into L2 frame addresses? This is different to what Steve mentioned. He said that the WLC is examining the mscb first than forward the packet based on exist or not exist the des...
