Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A Nexus 93180YC-EX on 7.0(3)I7(4) exports Neflow to WhatsUP but it all arrives as HOPOPT / IPv6 Hop-by-Hop Option, no application data is seen, it is an IPv4 network.
It has been posted about but I can't find anything relevant to the Nexus, does anyo...
Firepower Management Centre stops recording the user to IP mapping info and creates the ‘User Identity Dropped: User Limit Reached’ messages at between 17,000 and 18,000 users, this is nowhere near the 50k license limit for users.
My client is trying to get their Netflow devices showing in the Assurance license. They have added a number of devices to Prime. These devices have synced with prime and are consuming lifecycle licenses. When they try to add the devices to the assu...
When you try to download IOS XE Denali 16.3.5 a software advisory notice pops up although the code has not been deferred. This doc is referenced -
https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Intelligent_WAN/release/notes/iwanrn-2-2-...
ISE is on 2.1 and base licenses are incrementing daily, currently at 28k when 10k base license is installed. Actual ative connections is around 8k. This must be a bug. CSCul30358 seems likely but listed only for 1.2. It is a very poor bug as liste...
Well yes, I checked the documentation too. I was hoping someone would have something similar that resulted in a private bug ref or solution, there is no existing public bug. I can't raise a TAC case without exhausting other avenues.
Thanks very much for replying, there are no devices under Data Sources although apparently lots have been configured for Netflow so I'm checking the config.
