Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI have in the LAB hub ans spoke NBMA topology 1 hub and 2 spokeand i was started EIGRP, HUB was push default route to the spokes.i need some changes only in the HUB side what will be change neighbor metrik only one neighborif i change the interf...
Helloi have ipcc 3.5 where i have configured different cti route point and different IVR script but agents is same all calls from both IVR comes to the same agents i need gave priority to the one of CTI route point number call Please Help How can i ...
HelloI need some help i have 2 core switch what is connected to the asa and i need configure failover asabut my problem is my core switch is interconnect with L3 Link so my question is can i have one l3 link and 2 L2 link in the same 2 core switch my...
I had a similar issue, for me problem was that the version of ISE compliance module instaled on PC was higher than configured on ISE,You need to have the same or lower version of the compliance module installed on PC, if the version is lower AnyCon...
Hellobut i have configured frame-relay in the physical interface so if i use offset-list it will change to both spokebecause both spokes was conected to one HUB serial interfaceThank you
