Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i am having problems with the oui-enabled voice vlan config on a C1300 switch.Gig 1/0/3 and 1/0/5 both have a phone connected (Unify brand). Both phones show vlan 109 as their voice vlan. Switch config on Gig 1/0/3 seems to work, for config on Gig...
I have a C8200-1N-4T, IOS XE Version 17.09.05a, with license ROUT-P-C8200-E-7Y.The license shows up in software.cisco.com as three separate items: "Router US Export License", "Routing DNA Essentials Tier0" and "Routing Network Essentials Tier2".The r...
This guidehttps://www.cisco.com/c/en/us/products/collateral/routers/catalyst-8300-series-edge-platforms/cat-8300-8200-series-edge-plat-og.htmlconfuses me regarding the "mandatory DNA" license:Is ROUT-P-C8200-E-7Y (Catalyst Routing Essentials) all i n...
The management function of 240ac Wifi accesspoints does periodic radius requests with a user named "cisco-probe". Part of "Active Fallback" radius mode.Currently these requests fail, and fill up my logs.Which password does this "cisco-probe" user hav...
i have an existing network of 1850i access points with Mobility Express. Can i add 240AC access points to the same VLAN? Can they coexist in the same VLAN, or even join to each other?
i changed all the vlan and voice settings on port 5 via GUI (to something and back). I could not find any differences to the CLI, not when viewing the config, and not how it behaves.Will reboot the switch tomorrow and see if that makes any difference...
no change. After disable/oui-enable i have rebooted the phones.The switch sees the MAC, but does not activate the voice vlan when in "switchport mode access":show mac address-table int gig 1/0/3Flags: I - Internal usage VLANAging time is 300 secVlan ...
In "show voice vlan" (see starting post), the port with "switchport mode general" shows "Yes" in Activated column. The port with "switchport mode access" shows "No".Bug or feature?
