Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About andrewchan01
08-18-2017
Stats
Member since
07-21-2008
19
Posts
5
Helpful
0
Solutions
Re: Understanding Cisco 5508 WLC Licens...
in Wireless - Mobility Documents
08-29-2013
07:02 AM
08-29-2013
07:02 AM
I want to ask if my 5508 currently has 12 AP license, if I buy 2pcs of L-LIC-CT5508-5A, is it able to handle 22 APs?
... View more
03-24-2013
11:38 PM
I always can't add switch on fabric. I want to know how to add it? anyone tried before?
... View more
Labels:
03-24-2013
11:37 PM
I want to know how to put the module online show module Mod Ports Module-Type Model Status --- ----- ----------------------------------- ---------------------- ----------- - 1 48 O2 48X10GE/Modular Supervisor N5K-C5596UP-SUP active * 2 16 O2 16 port flexible GEM N55-M16UP ok 3 16 O2 16 port flexible GEM N55-M16UP ok 4 0 O2 GEM with L3 ASIC N55-M160L3-V2 offline
... View more
Labels:
01-16-2013
05:19 PM
Any one know is it work on N5K and N7K? Sent from Cisco Technical Support iPad App
... View more
Labels:
01-16-2013
07:03 AM
Anyone know why I got below error message when config Private VLAN? Error: while enabling/disabling service: private-vlan, err: Private-vlan is not allowed in F2 VDC (0x40e4005d)
... View more
Labels:
01-16-2013
07:02 AM
I got the below error message when I config private vlan on N7K with F2 module Error: while enabling/disabling service: private-vlan, err: Private-vlan is not allowed in F2 VDC (0x40e4005d) Any one know about it?
... View more
Labels:
01-07-2013
04:53 AM
I want to ask if my Vswitch on the VM ware has using 1st time Private VLAN and at the N5K can I use apply second time Private VLAN? VM Servers <--- Trunk---> N5K First VM has primary vlan say 100 First VM secondary vlan say 101,102,103 Second VM has primary vlan say 200 Second VM secondary vlan say 201,202,203 So will N5K able to has following PVLAN config Primary VLAN 300 Secondary VLAN say 100,200
... View more
Labels:
Created by
andrewchan01
in Other Data Center Subjects
in Other Data Center Subjects
12-27-2012
06:53 AM
12-27-2012
06:53 AM
I want to know if I have pair of Cisco 4500X that form VSS and each of 4500X has 1 link to one of the N7K. Is it similar with a Server(pair of 4500X with VSS) using vPC to the N7K? What is the mac-address learning behaviour?
... View more
Labels:
12-11-2012
05:44 AM
Already relased Current release IOS XE 3.4.0SG—December 5, 2012 This release note describes the features, modifications, and caveats for the Cisco IOS XE 3.4.0SG software on the Catalyst 4500-X Series switch, Cisco IOS XE Software Release 3.4.0SG delivers new software and hardware innovations in campus access and aggregation deployments that span across many technologies including Security, Video, HighAvailability, NetworkVirtualization, IPMulticast and Lower TCO as following: High Availability • Virtual Switching System (VSS) – Layer 2 Multichassis EtherChannel (MEC) – Enhanced Port Aggregation Protocol (ePAgP) split brain detection method – Cross-chassis Nonstop Forwarding with Stateful Switchover (NSF/SSO) – Cross-chassis in-service software upgrade (ISSU) – Support for virtual switch link (VSL) on 1 Gigabit and 10 Gigabit links – All four ports on quad supervisor scenario may be used for uplink
... View more
12-10-2012
07:58 PM
I have 4 pcs of 4500X and want to form 2 pairs of VSS and in between will have 2 X 10G link running on layer 2 etherchannel. I want to know that if I use load balancering method of SET A with src-mac and use load balancering method of SET B with dst-mac. Will it ensure that those inbound and outbound traffic is using one of the particular link?
... View more
Labels:
11-26-2012
11:09 PM
Layer 3 ECMP routing is it support without Layer 3 module ? Also I want to confirm that is it possible to have 1 link for Peer link only?
... View more
Created by
andrewchan01
in Server Networking
in Server Networking
11-26-2012
06:52 AM
11-26-2012
06:52 AM
If not using layer 3 module what kind of layer 3 feature is supportted?
... View more
Labels:
Created by
andrewchan01
in Other Data Center Subjects
in Other Data Center Subjects
11-26-2012
06:51 AM
11-26-2012
06:51 AM
Just want to know if no layer 3 module will it support ECMP routing and VLAN based QoS and ACL?
... View more
Labels:
Created by
andrewchan01
in Data Center Documents
in Data Center Documents
11-26-2012
04:53 AM
11-26-2012
04:53 AM
Just want to know if no layer 3 module will it support ECMP routing and VLAN based QoS and ACL?
... View more
Labels:
Created by
andrewchan01
in Wireless - Mobility Documents
08-29-2013
08-29-2013
I want to ask if my 5508 currently has 12 AP license, if I buy 2pcs of
L-LIC-CT5508-5A, is it able t...
03-24-2013
I want to know how to put the module online show moduleMod Ports
Module-Type Model Status--- ----- -...
01-16-2013
Anyone know why I got below error message when config Private
VLAN?Error: while enabling/disabling s...
01-16-2013
I got the below error message when I config private vlan on N7K with F2
module Error: while enabling...
01-07-2013
I want to ask if my Vswitch on the VM ware has using 1st time Private
VLAN and at the N5K can I use ...
Created by
andrewchan01
in Other Data Center Subjects
12-27-2012
12-27-2012
I want to know if I have pair of Cisco 4500X that form VSS and each of
4500X has 1 link to one of th...
12-11-2012
Already relasedCurrent releaseIOS XE 3.4.0SG—December 5, 2012This
release note describes the feature...
12-10-2012
I have 4 pcs of 4500X and want to form 2 pairs of VSS and in between
will have 2 X 10G link running ...
11-26-2012
Layer 3 ECMP routing is it support without Layer 3 module ?Also I want
to confirm that is it possibl...
11-26-2012
Just want to know if no layer 3 module will it support ECMP routing and
VLAN based QoS and ACL?
Public Statistics
| Date Registered | 07-21-2008 02:36 AM |
| Date Last Visited | 08-18-2017 03:56 AM |
| Total Messages Posted | 19 |
| Total Helpful Votes Received | 5 |
