Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Floks, I am trying to register AP to WLC , But it is not registering and more basic problem i found on the switch is ,AP mac address is assigned with 2 IP address, . I suspect 2 Ip address assignment for single mac address is creating the problem...
Hi, Below is the debug output. Mar 20 17:20:15.979: del_node src X.X.X.X:500 dst X.X.X.X:500 fvrf 0x0, ivrf 0x0 *Mar 20 17:20:15.983: ISAKMP:(1001):peer does not do paranoid keepalives. *Mar 20 17:20:15.983: ISAKMP:(1001):deleting SA reason "Death b...
Can Some one help on the below VPN Issue, I can see tunnel is up but interesting traffic is not passing through. Mar 20 17:20:15.979: del_node src X.X.X.X:500 dst X.X.X.X:500 fvrf 0x0, ivrf 0x0 *Mar 20 17:20:15.983: ISAKMP:(1001):peer does not do p...
Hi folks,Client published the applications Through VM, VM will launched by Citrix URL. Users will facing slow response while Working on the VM like if they open notepad on the VM if they typing something its appearing after 10 sec’s When they working...
Go to Cisco.con and downloads you should have a valid cisco id
here you you with the procedure for iOS up gradation
http://www.cisco.com/c/en/us/support/docs/routers/3800-series-integrated-services-routers/49044-sw-upgrade-proc-ram.html
Sub interface should be created on router , hope you are creating on the router
may be iOS on router is not supported, you may have to go for iOS upgradation
post me rhe router model
Router1#enableRouter1#configure terminalEnter configuration commands, one per line. End with CNTL/Z.Router1(config)#access-list 10 permit 192.168.X.X 0.0.0.255Router1(config)#ip nat pool Publicpool 117.254.X.X 117.254.X.X netmask 255.255.255.XRouter1...
