Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community,I am trying to locate the ASR 1000 (1004 specifically) system limitations for VRF lite.I am after info such as max OSPF process, with associated timersmax VRFmax BFD neighborsmax tracking objectsmax RIP IPV4 address fam...
Hi Community,I would appreciate any input other may be able to provide on the behaviour of ASA when in Transparent mode.I have a few scenarios and am looking to confirm stateful inspection behaviour for.By default I shall block all traffic.1 - Flow i...
I have been searching around trying to find a decent solution to the above, without much luck.Is there an approach to setting the RAS QOS on gateways and gatekeeper. The default is 0x0 which is not good. Using an ACL seems like a very clunky approach...
Hi, I would much appreciate a little input from those with greater knowledge as to the various ways to find out the CCM cluster name for previosuly deployed servers. Currently running 4.1.3.Many Thanks
Hi,Does anyone know of an implemented method to provide PE Node Protection? Failover time is key here.Network topology has pair of PEs at each site, with each PE connected to a seperate P. The 2 PEs at each site are connected and link protection is i...
Thanks for the quick response.As you will see in the test I posted, I do not propose to have acl on the outside to allow return flow for inside (higher security level) initiated traffic.I use acl on inside (higher) because I want to control exactly w...
David, A few answers below. I am sure others will correct me if I am slightly off the mark.1 - Metrics on tunnel headends will be seen for Autoroute tunnels. It is the best IGP metric to the Tunnel Deistination, which is seen in the table.A TE tunnel...
