Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a 1921 with 3 interfaces. One for the LAN and the other 2 are wan each with a public address. The 2 wan interfaces are used for redundancy. I would like to know how I can static nat the same port and inside address on both wan interface...
Hi,I have configured my WAP321 with captive portal enabled but how to a get to the captive portal. If i browse to its web address and get back into the administration GUI and if i connect to the wireless connection configured on this AP it does the n...
HiI'm having a problem knowing where to go to get my WAP321's captive portal. If i type the IP address of the WAP321 it simply takes me into the Administration page.
Hi,I'm hoping someone can help me with the following solution.I have 2 PBX's for redundancy and 2 SIP trunks. If the SIP Provider fails on the primary SIP and will automatically send the incoming calls down the 2nd trunk. but the issue i have is that...
OK i worked out that the nat statements do work. The way i did the LAN side out to the active WAN is use ip sla with track. so if the gateway for the fibre WAN x.x.x.157 is reachable then it will use it as the default gateway if down and use the next...
Hi Alain,This is what i did. I normally use the interface, which in this case would have been g0/0 and g0/1 but the extendable command wouldnt show, so i used the actually ip address of the interface. is that correct. it isnt workingbelow is a the co...
HiWhen I connected to the wireless it simply authenticated the usual way. Then started my browser and could get to the Internet. I was hoping or thought that I would have to use the website/ captive portal to login into the wireless and authenticate....
