Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I noticed when I first place aggregate-address 10.34.0.0 255.224.0.0 summary-only and than 10.40.0.0 255.255.255.0 to advertise more specific, that route is not placed. If I take out 10.34.0.0 and put 10.40.0.0 and than put 10.34.0.0 back, I can see ...
What is the best place in a network to redistribute a default route from? Distribution, Edge distribution, Core? Right now we have our two routers attached to a distribution and sending a default inside. We are thinking to move them and attach them t...
Question. Best practice is to configure iBGP via loopback interface. My question is, is that valid statement for scenario where two BGP peers are seperated by a firewall?
Mu question is how to generate a default to ISDN spokes (EIGRP on the LAN). Right now we have: ip summary-address eigrp 10 0.0.0.0 0.0.0.0 5 ; applied on the interface where all ISDN spokes are. That generates default for all the spokes. That worked ...
Hi,I wonder if anyone can help with my concern. Let's say we have 100 subnets. I want to prepend only half of them. So I'll build a route-map applyed on BGP neighbor matching the prefix-list of all those subnets and setting a prepend. But how to prep...
Nobody said here it will throw you out from console.All I was saying you can't modify it since authorization doesn't allow you to get to startup config!modifying run as people suggested and than copy startup will overwrite run..so it won't work
So almost everybody hear gave stupid answer..remove aaa or add enable privilege level 15.
None of those will work since you can't login because of authorization failed. Some suggested do it before you copy config..beautiful..but when you do that you ...
Same issue here.I tried 3 different USB to serial adapters, 3 different blue cables..Looks like it's brick at this point.I think it happened when ASA saw multiple MAC addresses on non trunk port coming from my ESX servers with that switch card config...
other question.So site sending aggregate of two routes will keep advertising the aggregate even when it looses one of those routes?like 192.168.0.0/16 when 192.168.10.0/24 is lost it will keep sending an aggregate until second routes is gone, right ?...
