Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks,
I would like to seek help regarding a simple straight to straight cable connection from my newly purchased Cisco SG500-28P to an existing Layer 3 Huawei switch.
My configuration is just simple for SG500:
1.Vlan 1
2. Management ...
Hi guys, Good day! I would like to ask a questions if it is possible to run the VPN in RV180W even it is set to AccessPoint or WDS Bridge mode? currently our set up have a CPE router: HPA-MSR900 (ISP own) and a ASUS RT-N12HP for the wireless inf...
Guys, I have an issue regarding the UCCX agent functions of transfeering call internally.- Reported issue was one extension was not working - The user did initial steps to correct the issue such as logging out of the cisco desktop agent clearing...
Hi guys, I need your expertise regarding how to convert from autonomous to LWAPP using AIR-SAP2602i-s-k9 with IOS version of ap3g2-k9w7-xx.152.-2.JA. I'm following these commands but it is not available debug capwap console cli or debug lwap...
Hi all, I have a problem regarding our voicemail system using a CME-CUE infrastructures. It seems that if our Sales and Marketing dept are all busy or no one answer the call it will call forward to the other dept (Reservation). In reality the v...
I just resolved my own issue :By removing some extension number included in the ephone-hut 1 configThe following example defines sequential hunt group number 1. When callers dial extension 5601, the first phone to ring is 5001, then 5002, 5017, and 5...
Hi all, Thank you for the reply, It is a really big help By the way I just found out that Cisco RMA team is not updating their records once they replace a faulty device. Currently I'm struggling to open a TAC case with Cisco because the serial n...
Hi Dharmesh, I configured a default call protocol to H.323 on my end-points. I got a transform and search rule to add domain for SIP dialing. So I need to deactivate these policies ? But what if I call from my EX90 to SIP endpoint only like a E2...
HI, I used single VCS Control Deployment 1. Singapore is my HQ site for my Tandberg Ex90 and C402. Hong Kong is my Branch site with EX90 and C40All end-points are registered in VCS controlAll used a Dual protocol registration (H.323 and SIP)My under...
