Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to test array to array replication using Pure Storage FlashArrays FA-X20R3.The ethernet switch is a model N9K-C93180YC-EX.The Pure Storage interfaces support 10./ 25 Gbps connection - according to Pure Storage technical support.The storag...
I have an IWAN Master Controller deployed on a VMware virtual machine.Appears that VMware Tools is added to the VM image - not sure if it is VMware tools or open-vm-tools.According to the vSphere client, VMware Tools is running, but the IP informatio...
I installed an UCSC-MRAID12G controller and 2 x SSDs in a C220 M4.Configured the controller, creating a virtual disk, the disks are visible via the option ROM on the console.When I run the ESXi installer, the disks are not found.Any information why t...
I have a C220 M4 that I attempted to boot from an ISCSI target from the embedded Ethernet ports.I can add the IQN with no issue.When a try to “Add an Attempt, I receive the following message. I checked the Network Stack – it is enabled, but I’m not s...
I am repurposing a B200 M5.The server has 2nd Generation Intel Xeon Scalable ProcessorsI have 2 x 64GB and 2 x 32GB DIMMS.Referring to the Cisco UCS C220/C240/B200 M5 Memory Guide, I'm not sure what is the preferred method of populating memory.Should...
Unfortunately, I have another blade B200 M5 stuck in the chassis. The release lever doesn't release server. I can't determine what may be holding the server in the slot. Doesn't appear to be a locking mechanism.
I'm facing a similar issue.I have B200 M5 blades with a Cisco Boot Optimized M.2 Raid Controller (UCS-M2-HWRAID) and 1 x 240GB M.2 6G SATA SSD (UCS-M2-240GB)I don't see an option to configure as a JBOD, so configured as RAID0.I cannot see the disk pr...
